Main > Project Announcements
Let's try economy powder coating at home
PL1:
--- Quote from: yotsuya on February 19, 2013, 09:41:27 am ---Griff, I'm curious. How do you plan to join the two units?
--- End quote ---
Given that he deliberately searched out a toaster oven model with controls below the door, he'll probably:
1. Cut a hole in the right side of one just above the lower sliding rack support
2. Cut a hole in the left side of the other
3. Push them together to create a single heating chamber
4. ? ? ?
5. Profit ;D
Scott
yotsuya:
--- Quote from: PL1 on February 19, 2013, 01:49:10 pm ---
--- Quote from: yotsuya on February 19, 2013, 09:41:27 am ---Griff, I'm curious. How do you plan to join the two units?
--- End quote ---
Given that he deliberately searched out a toaster oven model with controls below the door, he'll probably:
1. Cut a hole in the right side of one just above the lower sliding rack support
2. Cut a hole in the left side of the other
3. Push them together to create a single heating chamber
4. ? ? ?
5. Profit ;D
Scott
--- End quote ---
I get THAT. It's the ? ? ? that I am curious about.
PL1:
--- Quote from: yotsuya on February 19, 2013, 01:51:49 pm ---I get THAT. It's the ? ? ? that I am curious about.
--- End quote ---
That is where after preheating, you open the doors, thread the long powder coated piece through the hole (the trickiest part), and hang it from some hooks to bake.
It will be easier to use if the hole extends all the way through the front edge, leaving a C-shaped side, with a metal flap added to cover the gap between the doors.
Scott
griffindodd:
--- Quote from: PL1 on February 19, 2013, 02:13:45 pm ---leaving a C-shaped side, with a metal flap added to cover the gap between the doors.
--- End quote ---
And this is why Scott wins all the internetz points, this is exactly what I plan to do.
Sent from my SAMSUNG-SGH-I717 using Tapatalk 2
yotsuya:
No, I GET all that. I can visualize that. Scott can keep the Internet points. I'm just curious how YOU plan to do it. Wishes and twine are cheap, but I figure you would go one better.
I tell you what, I'll just shut up and wait for you to post the photos of the final results.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version