Main > Project Announcements

7 Inch Pac-Man

<< < (11/11)

griffindodd:
Well done, an excellent build and a great way to learn some lessons before thowing yourself into a bigger cab. In fact you'll probably find a bigger cab easier in many aspects due to the tiny scale you were forced to work at on this build.

lohkoqz:

--- Quote from: Mungo9000 on October 09, 2012, 04:36:11 pm ---Yeah, I see what you did.
I'm not sure if it's FUBAR or not, I never peeled back the buttons that far. My guess is that it isn't. I can see four contact points in each corner where the button used to be, but I can't see anything in the middle, this suggests to me that the button press is making a contact between the top two corner contacts and the bottom two.

Looking at your image closely, the top two seem connected and I would make a guess that these are the switch and the two lower corner contacts are the common/ground.
You need to power up the unit and try putting a piece of wire between the top and bottom contacts to see if it works.

This is a super fiddly job but the end results can be great.
Good Luck.

--- End quote ---

Thanks for your advice..
will try to connect 4 contact point
i will report as soon as i fix it

wooodyii2:
What was the PN for the buttons?

PL1:
Welcome aboard, Wooodyii2.


--- Quote from: wooodyii2 on December 28, 2012, 08:57:59 pm ---What was the PN for the buttons?

--- End quote ---

Based on this post, I think he used these.


Scott

Navigation

[0] Message Index

[*] Previous page