Arcade Collecting > Pinball
Jokerz! System 11 flipper not working
ed12:
hi
no i am clear they are tip36c
refer to page 80 of the manual
if u require it
i will up-load the pdf
ed
zero_koop:
--- Quote from: ed12 on May 04, 2012, 11:46:46 am ---hi
no i am clear they are tip36c
refer to page 80 of the manual
if u require it
i will up-load the pdf
ed
--- End quote ---
Thanks, I found the page and the reference to tip36c. I suppose I could test all 8 of them, but how can you tell which transistors go to the flippers, and to the left flipper for that matter?
Also, if you have any suggestions on testing transistors I'd appreciate it. I found another guide, but when I tested them using the guide I wasn't getting the right response so I may have been doing it wrong or the guide wasn't clear.
smartbomb2084:
This game is NOT Fliptronic... NO transistors in the flipper circuit.
The transistors on the Auxiliary Power Driver Board (page 80) are for solenoids.
Check F6 -Auxiliary Power Driver Board.
Use the metal plate in the backbox like Jim said for GROUND.
Probe BOTH sides of F6 for Flipper Voltage.
ed12:
smartbomb2084
lord why did u not metion the troubleshooting guide ?
or the fact the realy is on that board ?,ya u know the 1 that control's the realy ?
huh
next time :cap's: off thk-u in advance
try this the next time
huh ed the realy :flipper-control-is-on-that-aux-board:
but they are not transistor controlled :the flipper's: ?
would make your reply a little more under-stand-able
there is 1 fuse yup
but the nick said it is good
the nick said the board was trashed
read the full thread first please
a nick here said the same thing i thought
replace it with a another 1 if it work's move on
if not refer to trouble shooting
i think that's why they put it there ?
correct me if i am wrong
thk-u in advance for the cap's and flame
ed
smartbomb2084:
First of all the Relay on the Auxiliary Power driver board is for 'A' or 'C' solenoid selection NOT flipper ground.
The Relay for flipper ground is on the CPU board at 1J19-1 and 1J19-2 and it IS transistor contolled by Q67 a 2N4401 NOT a TIP 36C.
Man you need to learn to write legibly or find a better translator or find a forum that is in your native language....
TRYING to read your gibberish posts even gives the most patient person a headache.
What good are tech related posts if you can't read them?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version