| Main > Project Announcements |
| Bartop - "NEONCADE" |
| << < (5/10) > >> |
| firedance:
Yeah they fit fine, although I did have to drill a small recess for each shaft, it was that or rebate the joystick mounting plates so I took the easier option :) |
| JDFan:
--- Quote from: firedance on August 19, 2015, 03:06:55 pm ---Yeah they fit fine, although I did have to drill a small recess for each shaft, it was that or rebate the joystick mounting plates so I took the easier option :) --- End quote --- Good - was a bit worried as I had run into the same sort of issue when building my robotron bartop the Happ competition joysticks fit but wouldn't move so had to remove about a 1/4" of the 1/2" MDF under them - and even though the zippys are a bit smaller it still looked like a tight fit from the pic ! |
| firedance:
Glad it wasn't just me that encounted this er little oversight :) |
| firedance:
A couple more pictures ;D the holes on the top are for the usb speakers i have, might be installing a exhaust fan between the two, not sure yet. used "inset hinges" so the rear door will sit flush. the small hole to the right on the rear is for the power on switch, will grab a pic later ;) the rear rebate of the bezel i did free hand hence the slight over run :-[ |
| firedance:
Here's the Blue LED power switch, £1.29 shipped from china :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |