Main > Project Announcements
Bartop - "NEONCADE"
firedance:
Didn't take a picture of all the parts, they all work great for "sanwa" clones :)
was going to cut the sides today but er it's a little damp outside :badmood:
firedance:
Just a small update, borrowed a drill press from a friend, used 25mm and 30mm Forstner bits, mine from a case of 5 different sizes, got them a while back but never used them till now :)
surprised myself how good the bits were, used a template from slagcoin.com, dont we all ;D
CP size is 495mm x 218mm x 12mm.
So it begins at last.................
firedance:
Wow, didn't realise it had been 2 months since i last did a little work on it :-[
got most of the parts routed to size, only took pictures of the side, which measures approx 440x540mm, the entire width will be about 530mm
outside edges were routed at a 45 degree angle, first time i've used the router for this, turned out better than i expected.
firedance:
This is being worked on as i type...........................honest ;D
JDFan:
--- Quote from: firedance on August 19, 2015, 12:55:04 pm ---This is being worked on as i type...........................honest ;D
--- End quote ---
HAve you test fit the joysticks yet ??? -- ( looks to be very little depth in the CPO to fit them ) :dunno