Main > Project Announcements
Bartop Cabinet
JRChristenson:
It'll have one of Ultimarc's switchable joysticks, an Ultimarc trackball and about 19 buttons.
JRChristenson:
Finally getting back to this, put a coat of paint on everything this morning. Also, my office is a mess!
JRChristenson:
Working on this again, got the power button wired up last week. I might have this playable in the next week or so!
TopJimmyCooks:
JRC:
Did you end up soldering the power switch leads to one of the breakout boards at the front of the dell? Or was there a wire to tap into at some point past the ribbon cables back to the MB?
good looking bartop.
JRChristenson:
I connected them to the little board that sits at a funny angle at the front of the machine. Pins two and three of the 16 pin connector if I remember right. I just disconnected the existing connector, it only effects the power button and the LED lights on the front panel anyway.