The NEW Build Your Own Arcade Controls

Main => Artwork => Topic started by: mrclean on May 27, 2008, 02:22:19 pm

Title: Applying Artwork to Control Panel with an edge suggestions ?
Post by: mrclean on May 27, 2008, 02:22:19 pm

Should I only apply the artwork to the top of my panel or how do i apply it with multiple edges (http://img353.imageshack.us/img353/6133/5474875ro1.jpg)
Is it going to look awkward ? open to suggestions basically it bevels in

Title: Re: Applying Artwork to Control Panel with an edge suggestions ?
Post by: Stub on May 28, 2008, 02:08:52 pm

I am going to have the same issue I am using ---smurfette--- veiner, not t-molding, and I am not sure how to handle edges. My worry is wear of palms on the edges making it come un-attached.

Thoughts anyone?

Title: Re: Applying Artwork to Control Panel with an edge suggestions ?
Post by: nuka1195 on May 28, 2008, 03:53:01 pm

is ---smurfette--- veneer good stuff?

you could round the edge and wrap your overlay, if it's something that can be contact cemented or self sticking.

Title: Re: Applying Artwork to Control Panel with an edge suggestions ?
Post by: Stub on May 28, 2008, 04:16:44 pm

Doh! BIRCH