The NEW Build Your Own Arcade Controls

Main => Consoles => Topic started by: AE35 on July 30, 2007, 07:45:08 am

Title: Dreamcast rumble(jump) pack schematic?
Post by: AE35 on July 30, 2007, 07:45:08 am

Hey guys!

My cat is VERY sweet, but my wife's cat has a brain-problem, and he WILL claw at the door to
the bedroom every single night. I bring out the big watergun and hunt him down, but the next
day his head has been reset and we start all over again.

Now, I was watching some Farscape last night, and looked at one of the DC controllers lying on the
floor(I love DC even though I never had one back in the day) and removed the jump pack and
thought "hey, I could wire this baby up, lay it in front of the door with wires running to the bed
and then make it go KLAK-KLAK when he starts. He's easily scared you see.

But what pins are ground, + etc?? And is it 5v or 12v? Has anyone ever hacked them before?

Thanks for your time!

Nicholas :cheers:

Title: Re: Dreamcast rumble(jump) pack schematic?
Post by: HaRuMaN on July 30, 2007, 08:29:32 am

open it up.  You'll see a motor inside with red and black wires attached to it.  Attach your power (5V) to these lines, and that should do it.   >:D

Title: Re: Dreamcast rumble(jump) pack schematic?
Post by: AE35 on July 30, 2007, 08:33:52 am

Cool!! Thanks!!

I hope he's ready to run!!!! ;D