The NEW Build Your Own Arcade Controls

Main => Monitor/Video Forum => Topic started by: Doughbroz on December 26, 2005, 03:24:12 pm

Title: GO7 pic still not wide enough
Post by: Doughbroz on December 26, 2005, 03:24:12 pm

Installed cap kit and new horizontal width coil in GO7 CBO, B+ is 120V, width coil adjusted to maximum, but pic is still an inch short on each end.  Any other components that can be changed to widen the picture?  Thanks.

Title: Re: GO7 pic still not wide enough
Post by: Karetaker on December 26, 2005, 03:48:56 pm

On the G07 you can increase the microfarad value of "C515".  It should be a .53 microfarad, 400v capacitor.  Just make sure you replace with the same value voltage or higher.

Title: Re: GO7 pic still not wide enough
Post by: Doughbroz on December 26, 2005, 04:11:12 pm

Thanks Karetaker.  I will assume that the percentage increase of the value will result in a corresponding increase in width, and try it soonest.