The NEW Build Your Own Arcade Controls
Main => Project Arcade - the book! => Topic started by: chadandjody on November 23, 2005, 09:53:46 pm
-
Just curious as to why the plans in the book have cut you out two controls panel tops.
-
Just room left over so there's an extra, think the book even says somewhere that it's optional, but it's been a while since I wrote it :)
-
one is more of a prctice cp to make sure the cuts are right I think....
don't have the book with me at work to check (sorry Saint I won't forget it again)
but I do recall he states why in the book.
-
think the book even says somewhere that it's optional, but it's been a while since I wrote it :)
Ohhh..... Gunna use my detective qualities here.
Been awhile since you wrote it, and therefore read it...... This strongly suggests that at least for the moment there is no book 2 in progress or you would have most certainly been referring to it. :'(
Enquiring minds would like to know.
-
When making my control panel, I cut two in case I screwed something up.
I was right. Didn't glue the CP overlay on properly and was forced to rip it off. Unfortunately I couldn't get the glue off so it went in the bin.
Always double up if you can.
-
think the book even says somewhere that it's optional, but it's been a while since I wrote it :)
Ohhh..... Gunna use my detective qualities here.
Been awhile since you wrote it, and therefore read it...... This strongly suggests that at least for the moment there is no book 2 in progress or you would have most certainly been referring to it.