Build Your Own Arcade Controls Forum
Main => Lightguns => Topic started by: fjser on November 22, 2005, 05:00:19 pm
-
Subject line says it all. My new cab is going to use a PC monitor (21 inch). Whats the recommended light gun that is most compatible with mame?
-
Someone here must have an answer for this guy. I am looking for an answer too.
John
-
I thought the only lightgun which works with Mame is the ActLabs PC light gun (or Actlabs TV lightgun). Other than that I never heard of another which works with Mame.
http://www.act-labs.com/products/gun1.htm
-
Yeah, actually the Act-labs gun is the best option for a PC monitor. For a TV, you can choose between this and a guncon2.
-
I have a pair of GunCons (Scorpion 3) working perfectly at 640x480 resolution on a Wells Gardner D9200.
There are working as well or better than the Actlabs (which I also own), AND I can use two of them.
I'm using Smog's driver, and a home built circuit that provides +5 and +9 power to the guns and uses Andy Warne's jpac small chip to get the composite sync from the VGA signal.
If you can build a simple circuit on breadboard, this is a GREAT option.
There are several threads about getting the GunCons working on a PC and a PC monitor in these forums.
-
Do you think perhaps you could write up a little tutorial for us non-techies on how you did that? I think it be greatly appreciated!
-
Here here.
-
I'm working on a write up for my web page.
Admittedly, it will just be my experience / summary of information available at other places on this forum / SMOG's forum.
Hope to have it done in the next couple of weeks.