The NEW Build Your Own Arcade Controls

Main => Software Forum => Topic started by: jsansoterra on February 08, 2005, 06:03:14 pm

Title: Front end recommendation - XP / ARCADEVGA/ BETSON
Post by: jsansoterra on February 08, 2005, 06:03:14 pm

Greetings!

Title: Re: Front end recommendation - XP / ARCADEVGA/ BETSON
Post by: Minwah on February 08, 2005, 07:22:34 pm

Don't think EmuLoaded does low-res, I could be wrong tho.

MAMEWAH works with both AVGA & SlikStik, you might need to do some tweaking depending on how the inputs are mapped etc...  Personally I use 368x240 for the layout, it looks great IMHO.

I'm not 100% sure which other FE's support the AVGA, so I'll leave it up to the other devs :)

Title: Re: Front end recommendation - XP / ARCADEVGA/ BETSON
Post by: youki on February 09, 2005, 04:05:58 am

Hi,

Atomic Front End support the ArcadeVGA at 100% .
and runs on XP.

I didn't know the Slikstick.  But if it maps keyboard it should work without problems. Use the AtomicKey.Exe provided with the front end to configure it.
If it is a standard PC joystick it should too.

The web site is : http://www.atomicfe.com

Personnally i use layout in 256*256 or 640x288 .  But Atomic Front End support all ArcadeVGA resolutions. And you can use the same layout in all resolutions (strechting) and all Orientations.

It is very easy to configure.

Youki

Title: Re: Front end recommendation - XP / ARCADEVGA/ BETSON
Post by: jsansoterra on February 09, 2005, 10:42:42 am

Thanks for the suggestions! I'll check them out!

 :D