Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: MasTequila on June 24, 2004, 11:23:52 am

Title: Perfect 360 wiring
Post by: MasTequila on June 24, 2004, 11:23:52 am

Ok I did a search and I didn't really find anything helpful.

1. How do you interface them with a PC?

2. Can you daisy chain the 5v power and grounds or are they separate?

3. Is there anything else I should know about wiring one of these up?

If there is a site somewhere or some source with these answers just post it and I will have a look after I sit in the corner with the dunce cap on for not finding it myself. Thanks in advance.

~MasTequila

Title: Re:Perfect 360 wiring
Post by: rdagger on June 24, 2004, 12:33:53 pm

Try searching for P360.  You could also check out this thread:
http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=15006;start=msg117274#msg117274 (http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=15006;start=msg117274#msg117274)

Title: Re:Perfect 360 wiring
Post by: Thenasty on June 24, 2004, 03:01:55 pm

one question is, what interface are you going to use to hook it up ? If its an IPAC then you will have no problem at all.

Title: Re:Perfect 360 wiring
Post by: MasTequila on June 24, 2004, 03:52:03 pm

Thanks for the info, now the only thing left is if I can daisy chain them or not fro the ipac LED header. Anyone got the right answer to that?

Title: Re:Perfect 360 wiring
Post by: Thenasty on June 24, 2004, 04:25:11 pm

sure, you can take the 5volts off the IPAC LED harness, thats how I have mine hooked up.