The NEW Build Your Own Arcade Controls

Main => Monitor/Video Forum => Topic started by: alex_bb23 on April 11, 2018, 06:18:39 am

Title: Using J-PAC with an Makvision M2725C-82 monitor
Post by: alex_bb23 on April 11, 2018, 06:18:39 am

Hello guys,

I own an Makvision M2725C-82 monitor which (according with technical specifications) can support resolutions 320 x 240 / 640 x 200. I intend to use this in combination with CRT Emudriver 2.0... So, windows desktop can run at 640 x 480i and I'm not sure if this monitor can be capable to deal with this resolution... Could somebody tell me if this will work?

Thank you!

Title: Re: Using J-PAC with an Makvision M2725C-82 monitor
Post by: buttersoft on April 11, 2018, 08:18:21 am

It should work fine. Some sets handle interlaced modes better than others, with less flicker, but there's not normally a lot you can do about that.

And BTW you probably wanted to post this in the monitor/video section :)

Title: Re: Using J-PAC with an Makvision M2725C-82 monitor
Post by: alex_bb23 on April 11, 2018, 08:42:38 am

Quote from: buttersoft on April 11, 2018, 08:18:21 am

It should work fine. Some sets handle interlaced modes better than others, with less flicker, but there's not normally a lot you can do about that.

Thanks to the ATI 5450 there is less flicker.

Quote from: buttersoft on April 11, 2018, 08:18:21 am

And BTW you probably wanted to post this in the monitor/video section :)

You're right! Could somebody move this post in the monitor/video section?

Thank you!