The NEW Build Your Own Arcade Controls

Main => Monitor/Video Forum => Topic started by: deep-c on September 23, 2013, 12:19:02 pm

Title: Neotec NT 3602 chassis
Post by: deep-c on September 23, 2013, 12:19:02 pm

I have a Hydro Thunder 39" cabinet with a 36" monitor (Neotec NT-3602 chassis).  The HOT keeps blowing upon power-up; sent board out for repair after repairing myself-same issue-HOT blows and all capacitors are good.  What besides a bad neck or tube could keep doing this?  The power supply seems to be alright but what should the voltage/amperage be going from the Power supply to the monitor chassis?  I have been dealing with this for over a year and am losing the battle :censored:.  Any suggestions out there?  I have been actively seeking a replacement monitor however 36" VGAs or Tri-modes are hard to come by.

Thanks in advance for any help!

Title: Re: Neotec NT 3602 chassis
Post by: ed12 on September 23, 2013, 02:57:49 pm

your yoke

and that is not a joke

the yoke is out of freq,thus driving the horz sweep out of freq
or your flyback is shot
good luck on the yoke..they are made by a of shore co. long gone

ed