The NEW Build Your Own Arcade Controls

Main => Project Announcements => Topic started by: quintinbiker on May 15, 2012, 10:16:22 am

Title: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 10:16:22 am

Hi there, this is my 2nd buld, well, I had this wood lying around, sorry, didn't take pics of the cuts i made.

But here it is...

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 10:18:30 am

Gave it 2 coats of primer, had some rattle can spray paint in the garage, primed it gray.

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 10:21:36 am

Here i gave it two coats of blue, well, blue was the only color i had, and thought of doing something else, then i decided to try the blue.

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 10:25:19 am

Just for the record, this is the brand spray paint i use, Proudly South African.....

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 10:53:17 am

Gave it a coat of crystal clear coat, have to run to hardware shop in the morning and get some more, and cut the rest of the pannels.

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 15, 2012, 12:59:22 pm

I'll have to check that for you.

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 23, 2012, 12:56:13 am

I decided to make a change cause i wasn't happy with the color, so i decided that mat black might look better, and with a few coats of matt clear on the matt black the paint job will last longer. so, i went for matt black and yellow, looks awsome i think.

Title: Re: 60 in 1 jamma bar top build
Post by: DaOld Man on May 23, 2012, 10:07:40 am

Looking good!
Are you planning to not use T molding?

Title: Re: 60 in 1 jamma bar top build
Post by: quintinbiker on May 23, 2012, 02:32:03 pm

I'm thinking of using t molding but i don't have a router though, if i can borrow a router from someone and get the right bit i will put t-molding on.