The NEW Build Your Own Arcade Controls
Arcade Collecting => Miscellaneous Arcade Talk => Topic started by: wild_eyed on March 05, 2010, 10:46:10 am
-
i know the xbox isnt pc hardware but i figure someone here might be able to help me....
the xbox to jamma convertor is the one seen here:
http://www.arcademvs.com/VIDEO_ACCESSORIES.htm (http://www.arcademvs.com/VIDEO_ACCESSORIES.htm)
my monitor is a wells gardner 19k7601
my images are displaying white fuzz. but the games are displaying decetntly
(http://i159.photobucket.com/albums/t141/wild_eyed/DSCF0297.jpg)
(http://i159.photobucket.com/albums/t141/wild_eyed/DSCF0296.jpg)
(http://i159.photobucket.com/albums/t141/wild_eyed/DSCF0295.jpg)
on the jamma connector there are 5 pins relating to the video
Red
Green
Blue
Ground
and
Sync
the first four are fine i.e. i know where they go,
but on the monitor there are four places were the sync pin could go.
previous games send it to -H sync on the monitor
im sending it there now for the xbox as well
but there are also +H sync -Vsync +vsync that go unused.
any help would be greatly appreciated
-
tie the sync in with the last 2 pins H and V sync, thats how I had to do it with soft 15 and a break out cable on my wellsgardner
-
just to clarify, do you mean, take the single sync from the jamma and connect it to -V Sync and -H Sync on the monitor?
-
just to clarify, do you mean, take the single sync from the jamma and connect it to -V Sync and -H Sync on the monitor?
yes
-
ok will try this tomorrow
-
hi again.
i connected the i connected the -h sync and the -vsync of the monitor to the sync of the jamma but i still got the same line sthrough the monitor.
the pins on the monitor are as follows
1 Red
2 Green
3 Blue
4 Ground 1
5 +V Sync
6 +H Sync
7 Ground 2
8 -V Sync
9 -H Sync
wires from the jamma are:
Red
Green
Blue
Ground
Sync
Wires are running as follows:
Jamma Monitor
Red ----------- Red
Blue ----------- Blue
Green ---------- Green
Ground --------- Ground 1
+V Sync
+H Sync
Ground
Sync ----------- -VSync & -HSync
Should i be connecting the jamma ground to the other ground on the monitor?
thank you.
-
no no the + syncs, should be at the end of RGB connector.