Main > Main Forum

Shaft replacements for Omnistik / Suzo 500

<< < (2/2)

CUTWEST:

--- Quote from: emphatic on April 04, 2011, 07:32:21 am ---If you have access to a lathe:



--- End quote ---

supreme big question mark on my end dude. I dont get any of that. I would rather just buy it off anyone.

emphatic:
I hear you. All measurements are in millimeters, if you print it out and take it to someone with a metal shop, I'm sure you could get one made. I wish someone would just start offering a service like this for us. Or if one of the SUZO 500 seller could just start selling shafts like these, that would be even better.

Grasshopper:
You could try Franco B on this board. He's made custom shafts for people in the past. Actually I wouldn't mind a couple for myself. The Suzo 500s are excellent joysticks. It's just a shame the standard handles look so damned ugly.

Navigation

[0] Message Index

[*] Previous page

Go to full version