Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: WG 25k7107 chassis/Hantarex Monitor  (Read 1281 times)

0 Members and 1 Guest are viewing this topic.

MLew

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 114
  • Last login:May 10, 2018, 08:38:25 am
WG 25k7107 chassis/Hantarex Monitor
« on: December 23, 2009, 08:54:01 am »
Are these compatable?

I think the tube is bad in the WG monitor, and I don't know if I'm gonna mess with it, so I was gonna try to replace it with a Hantarex Polo 25 in monitor and just use the chassis of the WG....that is, if I is even possible. (Its an RCA tube on the polo if that matters)
Logged

grantspain

  • I personally prefer "bog trotter"
  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 6177
  • Last login:Yesterday at 09:21:43 am
Re: WG 25k7107 chassis/Hantarex Monitor
« Reply #1 on: December 23, 2009, 09:38:06 am »
connectors are different but the chassis specs should match near enough,double check the impedence of both the vertical and horizontal yoke
Logged
Pages: [1]
  
Go Up
« previous next »