Main > Main Forum

Rotate Happ Trackball axis 90 degrees

<< < (2/2)

SirPeale:

--- Quote from: csa3d on December 05, 2009, 05:18:15 pm ---i did a similar mistake on my trackball, i ended up swapping the boards then snipping the wires attatched them and swapping them.

-csa

--- End quote ---

Why didn't you just pop the pins out of the Molex connector and pop them back in?

Which is the next thing I was going to suggest to the OP.

csa3d:

--- Quote from: SirPeale on December 06, 2009, 10:57:37 pm ---
--- Quote from: csa3d on December 05, 2009, 05:18:15 pm ---i did a similar mistake on my trackball, i ended up swapping the boards then snipping the wires attatched them and swapping them.

-csa

--- End quote ---

Why didn't you just pop the pins out of the Molex connector and pop them back in?

Which is the next thing I was going to suggest to the OP.

--- End quote ---

That probably would have felt less destructive!  Swap the molex pins instead of performing wire surgery and your problem should be resolved.
-csa

mikeyv23:
I ended up recutting the trackball mount area of my control panel.  I didn't have to redo the whole thing, and in the end I guess it was easier.  Thanks for the suggestions!

Navigation

[0] Message Index

[*] Previous page

Go to full version