Main > Main Forum
What's needed to start Shoebox testing?
HanoiBoi:
--- Quote from: bungy on November 14, 2009, 10:24:19 am ---Make sure you get a lot of crimp connectors: http://groovygamegear.com/webstore/index.php?main_page=product_info&products_id=210
If you're getting Happ buttons, you'll need the .187 connectors NOT the .25
Ultimarc's daisy chain harness saved me a lot of time connecting all my grounds: http://www.ultimarc.com/JShopServer/section.php?xSec=6
--- End quote ---
Good call on the .187 connectors for the Happ buttons. What I wasn't aware of, and perhaps should have picked up on, was that I would need different size connectors (the .25?) for the Mag Stik Plus connections.
The daisy chain harness (for ground wire) was a good deal too. It came with about 28 female connectors and one male. The females went to all the controls' microswitches (buttons and Mag-Stik Plus) and the 1 male went to the IPAC4, as Queeg pointed out. Since the IPAC4 didn't have a female connection for the ground, I simply cut off the male connector, stripped the ground wire and inserted it into the IPAC4 GROUND screw down.
Navigation
[0] Message Index
[*] Previous page
Go to full version