Main > Main Forum
Touchscreen
bkenobi:
Just make the wood frame duplicate the mounting design of that bezel if it turns out to be a problem. As long as it works, you can always come up with something to make it look good.
Deadly:
Here's what I did for a 60-1 project. Keep in mind this is "butted" up against the back side of the board and not a touch screen. Also behind tinted glass. I show this because it was originally a standard 19" LCD that I de shelled.
An idea for you, Make the face out of 1" wood. Router out (counter sink) for the LCD (without plastics) and then create a nicely routered frame (like a window frame with edge desings) to exist over the LCD edges. In the frame pieces also create a counter sunk holes so you could screw them in and then add a rubber cap on top. Kind of like how laptop LCD's look I guess. I hope to start a juke project this winter. Kind of sharing my ideas with you ;)
DillonFoulds:
Maybe if it's just the bezel cracked, and it's holding stuff together, so you don't want to remove it, fabricate your own.
maybe use these brackets on the front, and frame the sides...
mr_doles:
Now that's what I'm talking about. I knew there was a reason I keep coming back to this board. Thanks for all the great ideas.
:notworthy: :notworthy: :notworthy:
Now the guy got a higher offer so I have to decide if I am going to go more or just get the 15" one off eBay that the guy has tons of and are cheaper.
Malenko:
honestly 15" is plenty, anything bigger is just icing on the cake
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version