Main > Main Forum

Joystick question - Happ Supers

(1/2) > >>

Hewskie:
So I've been using Happ Supers in my mame cab since I built it over 2 years ago and am very happy with them.  I probably should have done more research prior to purchasing them and if I were to do it again I would probably go with the U 360s. But that's besides the point. I'm growing tired of the bat handles and would like to add some ball tops. My question is:

Is there any way to just buy a shaft and ball top that can easily slot into my happ super base or do I have to purchase a whole new assembly? My control panel is 1/2 " MDF and my cpo is glued directly to it. the joysticks aren't recessed at all and I like the height they're at now, I don't really want to have to route the underside to recess a new joystick assembly and I don't want to spend a ton of money if I don't have to.

So I'm looking for the easiest, cheapest solution to adding ball tops to my cab, any suggestions?

Thanks,

Hewskie

bkenobi:
Cheapest?  Dremel the bat down to a ball.   :cheers:

Ginsu Victim:
Possible answer coming.....

Okay, contact Tornado Terry. He doesn't have them listed, but I know he makes them. See what he'll send you one for.

His site (check out the modified Supers further down)
http://www.tornadoterrys.com/surplus.htm

His email
TERSHAN@1SCOM.NET

Hewskie:

--- Quote from: Ginsu Victim on October 21, 2009, 04:18:50 pm ---Possible answer coming.....

--- End quote ---


OOOO   :o the suspense is killing me!  :o

thanks for looking into it!

Hewskie

Ginsu Victim:
See modified message above.

Navigation

[0] Message Index

[#] Next page

Go to full version