Main > Main Forum

U360 problems

(1/1)

theob42:
hey guys, so i plugged in my 2 U360's and the orientation is off. up is down left is right etc. now i know i can probably fix this by screwing it back in upside down but is there a waay to reset it. ive tried using utlramap and I can make a custom map to fix the issue but then its gonna be a pain making other custom maps where every direction is all over the place. 

secondly, on the second u360 stick i have plugged in, right is now up. so id have to route the hole sideways from the bottom (since the plate is rectangle), otherwise id have to use a custom map to get it to work properly. any ideas?

severdhed:
just unscrew the PCB and rotate it :)

theob42:
oh sweet. wasnt sure if that was possible

Navigation

[0] Message Index

Go to full version