Main > Main Forum

SNK Rotary ls-30 pin outs

<< < (2/2)

mcoaggie:
Thanks everyone.
Broke out the multimeter and ground is definitely pin 7, dead center.
So now I think I'll take an old floppy cable to build the harness. 



bkenobi:
I don't think the pin spacing is the same as a floppy cable.  If I remember correctly, it's slightly off and requires a special connector.  Now, you might be able to force it on there, but it might be pretty tight.  If you go that route, be careful.  As I'm sure you know...parts for LS-30s are pretty hard to come by!

Navigation

[0] Message Index

[*] Previous page

Go to full version