Main > Main Forum
Lighting coin door
Ginsu Victim:
I just meant that it's blocked in a way to keep the reject from falling out.
Applekid:
--- Quote from: Ginsu Victim on September 15, 2009, 04:12:33 pm ---
--- Quote from: BrianP on September 15, 2009, 04:04:37 pm ---But, any idea where to get lamp holder?
--- End quote ---
Talk to Divemaster127, a very reputable vendor here. Click his name to see his profile and send him a message. He has them pretty cheap. Here is his Buy/Sale/Trade post, but he doesn't list them on there.
http://forum.arcadecontrols.com/index.php?topic=47066.0
I'm pretty sure the Happ item number is 42-0351-00D (LAMPHOLDER F/PLASTIC MECH HOLDER). Last time he quoted me 79 cents each, if that's the right item. (It's been a while)
--- End quote ---
The only problem I see is that the lampholder hooks into the mech holder which the dummy door doesn't come with. Hard to tell from the picture... but, are those blocks screwed on or riveted? :(
BrianP:
--- Quote from: Applekid on September 15, 2009, 09:33:59 pm ---The only problem I see is that the lampholder hooks into the mech holder which the dummy door doesn't come with. Hard to tell from the picture... but, are those blocks screwed on or riveted? :(
--- End quote ---
Hmmm. Good point, not sure how I would mount these.
http://happcontrols.com/lighting/49094100.htm
And I think I will need to get in touch with Andy to make sure of the socket size of his bulbs.
- brian
Ginsu Victim:
--- Quote from: BrianP on September 15, 2009, 10:25:05 pm ---And I think I will need to get in touch with Andy to make sure of the socket size of his bulbs.
- brian
--- End quote ---
They are T3-1/4 wedge base
Finchbyrd:
The lights in my coin doors are instrument panel lights for a car, c161 I believe. Anyway, earlier I wired up my coin doors, easiest "wiring" I've had to do thus far. For my application, I needed a receiving type molex connector, and I just so happened to have a few from some fans from the case that I gutted to install into my cab. I cut all the wires at the other end of the molex, cut the red/black down to the connector because they wont be used, and left the yellow/black as it was. I had some 22 gauge wire and cut 4 strands to length. I attached some quick disconnects to the opposite ends, and spliced the 2 reds I cut to length together and then wrapped them around the yellow on the molex. I did the same for the black wires I cut and added disconnects to. I had some wire nuts in a drawer so I used them and electrical taped all of it together. Works like a charm. The hardest part was stripping both ends of each wire and adding disconnects. 8 strips and 4 crimps. I took pics but my phone is dead, I'll post them later if anyone needs to see how easy it is. I need to get behind the return buttons because one says 25c and the other says 50c. How can I do this, and modify both to say 50c?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version