Main > Main Forum

Mounting hole sizes?

<< < (2/2)

BrianP:

--- Quote from: Franco B on September 09, 2009, 10:58:29 am ---[Thread about cutting TB holes]

Are you using dust washers on top of your panel? If so your 28mm bit will be fine as the dustwasher will cover it.

I personally would use a 20mm bit but that's only as I have one to hand.

--- End quote ---

Ultimarc shipped 2 plastic covers for the joystick hole (which I assume is called a dustwasher, <sigh>  such a newbie), so I should be fine there.  After all the money I have spent on this, a couple more for a 20mm hole saw won't phase me.

- Brian

Haterot:
if that's the case get custom washers made. Ask the guy above.

BrianP:

--- Quote from: Haterot on September 09, 2009, 01:18:36 pm ---if that's the case get custom washers made. Ask the guy above.

--- End quote ---

Why would I need custom washers?  The ones from Ultimarc are larger than the 20mm.  I don't think any of the hole will be exposed even when the joystick is at the far end of it's throw.  I am new to all of this and need lots of hand holding.

- Brian

Navigation

[0] Message Index

[*] Previous page

Go to full version