Main > Main Forum
Ultimarc U-Track Problems
seinfeldfan64:
I've just purchased and installed a U-Track trackball... It doesn't seem to work right, spinning left and right the mouse cursor moves smoothly along the X axis. Spinning up the cursor moves rather slowly up, and spinning down the cursor hardly moves at all, kind of jumping up and down. I would assume this is an issue with the track ball hardware itself? I'm a rookie at this, what should I do?
fatfingers:
I would contact Andy at Ultimarc. He'll be able to get you going.
severdhed:
i had the exact same problem with my Utrak when i bought it. i contacted Andy, he had me swap the PCBs inside, as it turns out, one was bad...he quickly shipped me out a new one and i was back up and working in a few days
seinfeldfan64:
Thanks for the response guys. I'll contact Andy.
ultrageek:
I had the same problem with my HAPP 3" TB. Turns out I had the power wires connected to the sensor connectors and vise versa. Almost exactly the same behavior.
One axis worked, the other was jumpy and extremely slow.
After switching them , everything works great.
I'm lucky I didn't fry the boards in the TB.
Navigation
[0] Message Index
[#] Next page
Go to full version