Main > Main Forum
control pannel/winpac issue - please show me your mame wisdom
omnivorism:
--- Quote from: st on August 08, 2009, 05:46:44 pm ---
--- Quote from: omnivorism on August 08, 2009, 01:44:00 pm --- I know you can change the controls in those, but the default key config on the IPac is kinda wacky.
--- End quote ---
If the jumper is set to MAME, then the IPAC will be using the MAME defaults. So, it should behave with an untouched install of MAME.
--- End quote ---
I had already changed the defaults on every emulator I have so they were more universal.
omnivorism:
Strange.
I tried again, and as far as i know the only thing i did differently was highlight "debug mode" and it says "programed sucessfully". The only bad side to this, is that i changed all the player 2 keys to none for now. so i will have to program it again.
omnivorism:
--- Quote from: omnivorism on August 08, 2009, 07:00:03 pm ---Strange.
I tried again, and as far as i know the only thing i did differently was highlight "debug mode" and it says "programed sucessfully". The only bad side to this, is that i changed all the player 2 keys to none for now. so i will have to program it again.
--- End quote ---
reprogrammed with player 2 also in mind.
I'll just have to go through and make sure my wiring is all good and see how well it works now.
Navigation
[0] Message Index
[*] Previous page
Go to full version