Arcade Collecting > Pinball
Anyone here have experience in repairing williams pinball machines?
shardian:
Start reading and you'll understand. System 9 is technically an early version of System 11 hardware. The first section pretty much summarizes the differences.
dansoftcore:
Alright thanks for the link but I got called into work today so I'll have to read threw that tonight or tommarow
dansoftcore:
So at around midnight last night I checked some of the plugs and then she fired right up! It wouldn't go from game over to new a new game. But then as soon as I knew what was going on the free game bell went nuts and 7 was on the display on the cpu board... Lame... So I decided to take a break and have a look under the playfield. After lifting it and poking around with a flashlight I noticed part of the piece that pushes a ball into the part to launch it was broken off. It looked like a little arm and now that I think about it I believe the machine had a problem starting a new round right before the game would ugh start hah. Think that might be the culprit of all this?
dansoftcore:
I was hoping that would do the trick but no... I took a vid of what it does I mite upload it later if anyone cares!
ChadTower:
EOS switch on that coil?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version