Main > Main Forum

Need bezel help

<< < (2/2)

Haterot:
javeryh, your example gave me some good ideas, it hink what I am going to try is this.
1. Cut out a circle with a 12" radius
2. Cut to fit the entire space a piece of foam board
3. then cut a circle in the center with a radius of about 11-11.5" This will make the outter bezel's opening a little smaller than the monitor bezels circle.
4. then cut out the rectangle in the inner circle to expose the monitor.


javeryh:
I thought about the circle and I think it comes down to personal preference - if in fact you can see the outline of the circle on the inside underneath the gray tinted glass (which is actually doubtful based on another cab I built), I think I might like the appearance of two "black bars" on the top and bottom of the monitor instead of the circle showing on all 4 sides.  I don't know.  I guess I'll find out!   

I'm really interested in your write-up of the rotation aspect - the more information out there the better.  It looks very complicated in general but since there are a bunch of people who have figured it out I have some hope!  Your cab is looking great by the way.

:cheers:

Navigation

[0] Message Index

[*] Previous page

Go to full version