Main > Main Forum

Swapping HAPP buttons for Sanwa Buttons

<< < (2/4) > >>

Jack Burton:
I'm not sure that would work on 3/4" mdf

kowal:
it is for metal only, but  you can taste. buy ver. which has 2 cutting edges
maybe they are from three, do not buy from one cutting edges.

MrMojoZ:

--- Quote from: langdonx on May 28, 2009, 03:23:28 pm ---
ETA:  Maybe I'll just buy 6 Happ competition push buttons to see how similar they are to the OSBF 30's.

--- End quote ---

They feel nothing alike.

langdonx:
Nice... thanks for all the input.

A fine-toothed round wood file sounds like my best bet.  I think I'll try it on Player 2 side and see how it goes.

Is there a better place to order Sanwa OBSF30 buttons from?  LizardLick is only processing May 11th orders right now, so I'd probably have to wait 3-4 weeks if I did order them Monday.

jasonbar:
Or maybe use a half-round file, if you find one of a good size/curvature.  Might make your work go faster, but it might also over-file if you're not careful... :dunno

http://www.mcmaster.com/catalog/115/gfx/large/4218a16p1l.gif

-Jason

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version