Main > Main Forum

Joystick handle hole diameter?

(1/2) > >>

thecheat:
Looked around a lot by searching and in the wiki, but I couldn't find my answer. What is the diameter of the hole for the stick handle on a Competition joystick? 1.125"?

thecheat:
Bumping this today... I'd think someone would know this off the top of their head?  ???

Wolfwood:


Hmm?

thecheat:
Well yes, but I need the diameter of the hole where the shaft passes through the control panel. I don't want to go too big and not have the dust washer cover the hole. If I make it too small it's going to be difficult to re-bore with the hole saw and no center line.

If it's dependent on the thickness of the control panel, it's going to be 5/8".

Wolfwood:


That help anything?

its about a half inch, if the joystick shaft is what your talking about.

and you could look on google, thats all I got.

Navigation

[0] Message Index

[#] Next page

Go to full version