Main > Main Forum
Using Spinners for 1 & 2 player racing games - GGG Mini Racing Wheels?
Loafmeister:
Hmmm, I have the slikstik Tornado spinner (with the skirted knob). Understanding the issue of the knob needing to be "tight", I still found when I loosened it, there was enough resistance to the point I still had to use some effort to remove it. So with that in mind, maybe, just maybe it didn't need the screws to be tightened at all.
So on a whim, I decided to try using the spinner without the screws tightened and low and behold, it seemed to play identical. So to anyone who has this spinner, is it necessary to tighten it? Is the concern that over time, friction will ruin the inside of the knob and will make it too loose? I tell you, without the screws, it's obviously a cinch to swap the knob for the wheel.
TheShanMan:
I have a follow up question (Randy's plastic set screw solution really has me considering a switch to this spinner!). For those of you who have this steering wheel, what is the angle of the control panel mount? Mine has a slope of probably only 20 degrees, so I'm picturing a "bus driver steering wheel" type of setup rather than a normal car type of setup, and I wonder how happy I'd be with that. Anyone with that kind of a setup, and if so, does that kind of angle work OK for you?
Navigation
[0] Message Index
[*] Previous page
Go to full version