Main > Main Forum

maximus arcade + u360 + mapping

<< < (4/5) > >>

clickhea:
yes i been playing the tekkens on it

hit me up on aim

screen name = clickhea


clickhea:
if anyone can share how to configure MA to run with the pcsx2 emulator and the saturn emulator it would be appreciated.

the problem is these 2 emulators require the roms to be changed manually through the emulator themselves.  i been tearing my hair out trying to get these to work.


Todd H:
I don't use either emulator so I'm no help I'm afraid.

arzoo:

--- Quote from: Bender on April 24, 2009, 10:26:33 pm ---first open the  LEDblinkyConfig.exe
select Maximus from the FE drop down menu

then go to the Misc Options Tab

under the Joystick Digital Restriction section
check the u360  box, and if you have a resrictor

just below that in the other Options section check the # of controls you have
and make sure Enable debug log, verbose logging, (that will help with trouble shooting) and save unknown games are checked

then save

run maximus and open preferences and go to the configuration tab and then the ledwiz tab (I know you don't have a LEDwiz)
check Run LEDBlinky, and use LedBlinky Configuration, you must do this under each emulator you want a Map to load in

then run one game from each emu, don't worry It won't work right just yet but you need to do it (trust me on this)

then quit and go to the LedBlinky folder and open the LedBlinkyControlsEditor.exe
click import/unknown games

then pic the emulator you want to set a map for (the game doesn't matter)
it will ask you if you want this to be the default , say yes

go to common Tab hit new
from the control drop down pick the control type (JOY4WAY for most older emu's STICK is for analog) then check the box next to that that says Primary controls

click Ok, Ok, then save

Rinse and repeat for each emu

hope I remembered all that right :dunno


--- End quote ---

Bender - You've almost got it exactly right (very impressive)! The only additional option clickhea needs to check is "No LEDs Mode" on the "Misc Options" tab. Also, there's no need to turn on the Debug mode - the unknown games list will still be captured.

Encryptor:

--- Quote from: Bender on April 24, 2009, 10:26:33 pm ---
run maximus and open preferences and go to the configuration tab and then the ledwiz tab (I know you don't have a LEDwiz)
check Run LEDBlinky, and use LedBlinky Configuration, you must do this under each emulator you want a Map to load in

then run one game from each emu, don't worry It won't work right just yet but you need to do it (trust me on this)

--- End quote ---

Bender or Arzoo,

I was trying to follow your instructions for configuring LEDBlinky to work with MA. I'm using MA ver 2.10.6 and ver 3.8 of LEDBlinky. The problem I ran into has to do with the quote above. I do the LEDBlinky Config part and save it but when I go into MA and go to the configuration tab I do not have an LEDWiz tab to click on. What am I doing wrong?

Encryptor

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version