Main > Main Forum

Need suggestions on how to deal with T-molding Problem

<< < (2/2)

cmoses:
I had a similar problem on my first cabinet.  Get some thin (width) masking tape and apply it to the T-Molding along the spline, folding it over so it is on both sides.  You may have to apply a couple of layers like this.  It basically builds up the thickness of the spline and allows it to grip when inserted into the groove. 

evitagen:
I had this problem with my Control Panel... for some reason I cut the slots a size too big.  Not really sure why, since I did the rest of the cabinet the correct size.  Anyway... hot glue works great.  And it's so very easy.

Hoagie_one:
I went with the hot glue.  Worked awesome.

Navigation

[0] Message Index

[*] Previous page

Go to full version