Arcade Collecting > Pinball

Non CPU Playfield Lights Out - Recifier Board Nightmare...

<< < (2/2)

RichSorr:
your 7VAC does go through J1, i would rebuild that board if possible. If it seems unrepairable or you don't think its a task you could venture in, GPE has a replacement board for about 50 bucks. Not hard to install at all. Unfortunately, I don't think they have any available right now.

gajaman:
I've decided to go with a replacement board from GPE. I've never dealt with them before but so far they seem very helpful.

As I undertstand it, when I get the board I solder the wires from the transformer to the "E" points on the board and then rewire all of the connectors with the new ones that come with the board and that's it.

On my board the E points are soldered with the wires on the back, I guess this is the right way of doing it?

Navigation

[0] Message Index

[*] Previous page