Arcade Collecting > Pinball
The Vulcan Project
Cyberflexx:
I gotta get a few boxes of bulbs and a rubber kit for her as well..
What bulbs are needed for the head and playfield? I am assuming #44 and #46
I think this will be a fantastic machine for my mini collection. I am thinking about moving the pins to the garage and make a little spot for them. Not sure exactly how I am going to do that, though and the wife might not approve.. :dunno
Cyberflexx:
I forgot to mention that this machine is working about 99% now. I just need to track down wht the drop targets arent working.. should be pretty easy. I might do that later today, if I get time.
ChadTower:
In an EM it's almost always switches. Dirty, broken, disconnected, whatever, it usually comes down to switches.
Cyberflexx:
Drop target problem resolved.. it was a broken ground wire, just as I suspected. and the last target would not register a score and the wire for that was broken at the solder weld.
Targets are now fixed.
New issue:
the return ball kicker will kick the ball for the next play but the ball wont make it up the little incline in the track to the ball shooter. I took it apart and cleaned it, and the ball still wont roll up the track. The kicker is kicking hard and eventually after 4 or 5 tries, the ball does make it to the shooter lane.
Any thoughts on this one?
shardian:
Take the apron off and watch it do its thing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version