Arcade Collecting > Pinball
The Vulcan Project
Cyberflexx:
What.. no comments? gheesh.. this is my 1st PF swap and still way new on working on these things.
I have the flippers installed, the back arch installed. I put a cut peice of mylar under the flippers to protect the playfield from scraping up. I cut the mylar in a triangle shape and the wide of the flipper throw.
I am having a problem with one of the starburst rollover targets not registering, I will clean the switch and check solder joints as time permits.
shardian:
The comments thing is a bit disheartening isn't it? ;)
The pin forum is fairly dead here. Used to be the KLOV pin forum was better, but it is almost as bad now.
So....
Looks Good! Keep up the good work!!
Cyberflexx:
i resolved the issue with the ball return kicker. it was a broken insert that was causing the problem of the ball not having enough power to go down the little track.
soon this pin will be ready to go home. its in my office at work and i work on it during my breaks and lunch time.
Cyberflexx:
I started working on repairing my drop targets. I had bought a drop target on ebay for the parts. The drop target finger parts that are in the assembly connected to the springs were chewed up bad on the 5banker, and the 4 banker had a broken drop target bar that we have already repaired. I had been busy the past few days so very little has been done since the last post.
Cyberflexx:
I got most of the new rubber on the machine and most of the posts. I need 7 post screws that are not machine screw style. the other playfield had been repaired with machine screws and wood inserts but this other playfield doesnt need those. Soon it will be playable!!!! :applaud:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version