Arcade Collecting > Pinball
The Vulcan Project
Cyberflexx:
The playfield swap has begun.. 99% of the top of the PF has been removed. I am labeling some of the wires on the bottom to make sure I get them in the correct location. Hopefully I can begin on the actual moving of parts sometime this afternoon. Sounds like a lunch-time project, all week.
Cyberflexx:
All of the parts have been removed from the top of the playfield. I cleaned with Novus and waxed the new playfield, man is it shiny! I installed my new star roll over inserts and put on new pop bumper mylar protector sheets where the pop bumpers go.
This is going to be harder than I thought! Too many parts.. :-\
Cyberflexx:
I pulled all of the staples off the ground wire and hopefully today I can start the swapping of parts.
I bought a new staple gun so I can reattach the grounding wire to the playfield.
This is going to take hours!
shardian:
Well to be fair, you are starting with the most difficult task one can do in pinball repair. ;) Just be glad it is not a DMD pin with craploads of parts. Go overboard with your documentation/organizing, and you'll be fine.
Cyberflexx:
I got all of the little screws for the bulb holders out and a few other little parts. I put the new flipper bats on their flipper shaft and re-rubbered them. If I get time, I'll start unhooking the other parts. I have to do this during breaks and lunch.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version