Main > Main Forum
U360 owners and users with octagonal restrictor please chime in.
Ginsu Victim:
To each his own. I just tried them again without the restrictor and the throw was a tad too long for my tastes. As long as you like them, that's all that matters. (hard spring ftw!)
GaryMcT:
--- Quote from: isucamper on March 12, 2009, 11:20:50 pm ---
--- Quote from: ivwshane on March 12, 2009, 10:45:17 pm ---Did you have a circular restrictor to compare it against? If so what were your thoughts between the two?
--- End quote ---
I tried them both before going with the circular. I had a really hard time installing the octo plates. The mounting holes did not match up with the little pegs. Also, at first I had the octo plate on upside down, because it wasn't really intuitive to me which way it was supposed to go. Once I got it on correctly, I was suprised that there was very, very little throw left to the stick. Not nearly enough for my tastes.
I was testing with the medium spring and short shaft.
--- End quote ---
Which was is up? It doesn't seem obvious to me, and I don't see anything on the Ultimarc site about it. I have to assume that I have it backwards since it's impossible for me to install it as it is. :)
EddieArcadian:
Updating this old thread for back to the future readers. Andy/Ultimarc has just re-modeled and updated his version of the U360 Octagon restrictor plates to increase the throw a tad bit, and also correct the mounting holes. I say "his version", because there are other octo restrictors made for the Sanwa stick that can be used on the 360.
His comment on the update is in this thread:
http://forum.arcadecontrols.com/index.php/topic,139872.0.html
Navigation
[0] Message Index
[*] Previous page
Go to full version