Arcade Collecting > Pinball

Marco sucks

<< < (2/3) > >>

FrizzleFried:
I've ordered from Marco a number of times and even met the owner and his wife at a local Pin gathering (along with the owner of PinScore).   Nice group of folks.  I highly recommend them... and they DO backup their product 100%.

shardian:
I've dealt with all the pin dealers (pbresource, Marco, Bayarea, pinballlife), and all are competent, knowledgeable, and helpful.

Ken Layton:

--- Quote from: Paul Olson on March 07, 2009, 11:58:25 am ---Ken - Would you mind posting what was wrong in the schematic? I would like to update it before I need it as a reference.  :)

Paul

--- End quote ---

The end-of-stroke switch is shown connected incorrectly to the coil. The schematic shows one side of the EOS switch connected to the cathode side of the coil. That is wrong. It should be connected to the anode side of the coil instead. The connection to the center coil terminal is correct.

The manual shows the wrong connections on all three flipper coils.

Don't know if Williams sent out a "manual amendment" sheet for this machine or not.

shardian:
Scratch my above comment - I have never dealt with Marco. It was GPE I dealt with.

pinballwizard79:
Yeah I am sure they will fix it.

The real reason I made the post was to find out if the error was on their part or the manual because (those are wrong sometimes, ok a lot) I am not proficient in looking at a rubber ring & spouting off its size.

Not going to be the end of the world, just complaining a bit.

They did send me wrong assemblies before which I never got around to returning, due to a time constraint I ordered the correct ones since they wouldn't ship until getting the wrong ones back................time went by & I still have them :-(

Navigation

[0] Message Index

[#] Next page

[*] Previous page