Main > Main Forum

Think I fried my jamma board

(1/1)

swamprat96:
 :angry:
OK My fault. The jamma plug on this cab has no locating pin in it. I think I inadvertently put +5vdc onto the ground pin or even maybe +12vdc onto the -5vdc!

No burning or bang but no boot now either- and it did before

Any obvious thing to check? Its a lethal enforcer konami jamma board. I'm going to do a conversion anyway but I still feel pretty stupid

Turnarcades:
You may have permanently fried it either by burning and cracking some small tracks or toasting one or more of the rom chips.

Kevin Mullins:
Yup, done that before....

After doing that one time I always remember now that the power side of the harness always goes to the short section of the JAMMA edge connection on the board.
I don't even bother looking for a label or key anymore, I just want to know where the power side is.

What game was it ?

swamprat96:
lethal enforcers - not great but it worked before I touched it :cry:

Navigation

[0] Message Index

Go to full version