Main > Main Forum

CPanel wiring harness?

<< < (2/2)

stan2323:

--- Quote from: exo on January 29, 2009, 08:46:47 pm ---Are the wires in the parallel cable color coded so that I can find the proper matches on either side, or do i just remove all the rubber/plastic housing and manually inspect which connection each wire goes to?

--- End quote ---

The project I did, a small CNC machine, I used a multi meter after I had stripped the wire to check continuity from the wire to the pin/socket.  Then I labeled each wire with the number of the pin/socket it went to. 

Navigation

[0] Message Index

[*] Previous page

Go to full version