Main > Main Forum
Wiring Coin Mech
Visitor Q:
--- Quote from: Vaad on January 26, 2009, 03:12:03 pm ---
--- Quote from: Visitor Q on January 26, 2009, 03:09:15 pm ---I have mine wired up to my Ipac4, two wires from the coin mech. to the Ipac to use a key press.
--- End quote ---
How easy is that todo mate .. dose it come with instructions ? How do i tell what whire dose what .. i know the Orange and Black ones are Power / earth ... Also will the IPAC Mini do the same job ?
--- Quote from: Marky_1979 on January 26, 2009, 03:01:01 pm ---What cab was it? Golden tee
--- End quote ---
Bang on the money mate Golden Tee 2005
--- End quote ---
Real easy...
http://www.ultimarc.com/ipac1.html
The slots are pre labeled but you can use any.
One wire goes to coin labled on the Ipac and the other to the ground.
IPAC Mini should be all the same.
Vaad:
thanks for the advice guys .. i will look into poking the wire into the arcade button and see if that works .. if not i will IPAC it :)
CheffoJeffo:
It isn't quite as easy as folks have made out, but it is only slightly more complicated.
What you have is a coin acceptor, which isn't just mechanical device with a microswitch as is common here in North America. You'll need to provide power to the acceptor.
This thread will help as I believe the acceptor in question is the same (and, coincidentally, was started by Marky_1979):
http://forum.arcadecontrols.com/index.php?topic=83990.0
Marky_1979:
Yes just checked mine is exatly the same model mate
Vaad:
--- Quote from: CheffoJeffo on January 26, 2009, 04:34:19 pm ---It isn't quite as easy as folks have made out, but it is only slightly more complicated.
What you have is a coin acceptor, which isn't just mechanical device with a microswitch as is common here in North America. You'll need to provide power to the acceptor.
This thread will help as I believe the acceptor in question is the same (and, coincidentally, was started by Marky_1979):
http://forum.arcadecontrols.com/index.php?topic=83990.0
--- End quote ---
Right so let me get this right
Wire up with IPAC
For the voltage use the Yellow 12v and the Black 0v from the PSU and plug them into the power cables of the coin Mech ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version