Main > Main Forum

Wiring Coin Mech

<< < (4/5) > >>

Vaad:
Can't really get any good shots of it wired ATM mate .. if you need some help send us a pm and i will see what i can do to help out.

Marky_1979:
Will do mate i think i will be having a go at wiring the cab in next few days

Vaad:
I changed my post above the wiring .. check it out will give you all the info you should need

Marky_1979:

--- Quote from: Vaad on January 29, 2009, 09:14:59 am ---This is Coin Mech end

SW1 - No Wire
SW2 - No Wire
0v - Black Wire  .. This wire comes from the light bulb in the PCB board and back out again  -- Wire this into the Earth of where the power is coming from..  i used the PSU
P2 - Yellow with Black Banding  Coin 2 on IPAC
lamp - No Wire
12v - No Wire
MET - White wire  with Red Banding  -- Ignore this
12v - No Wire
P1 - Orange wire with Black Banding  -- Wires to Coin 1 on IPAC
0v - Black  -- This is the earth that needs to be wired into IPAC or what ever version you are using
Key - No Wire
12v - Orange Wire -- Wire this into where you want to take your power from .. i used the PSU 12V cable

--- End quote ---

Does it matter if I use the ground from this on only on the second ground imput on the ipac or will i have to split the ground so it goes into both groyund slots on the ipac? as i already have a ground wire in there for all the other controls. Also having issues with the wires on my coin door as when i use the player 1 coin and orange and black wire and what should be ground the ipac gets very hot very quickly so i unplug it as there is something very wrong, have i forgot to do something?

Vaad:
I have IPAC mini and it only has one ground cable.. i just pushed the coin grounds into the Grey wire of IPAC and all was fine.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version