Main > Main Forum

Anyone used a XXXX-1 Jamma Board before??

(1/3) > >>

Matsurigatzu:
I have the XXXX-1 connected and it comes up on screen and its running fine but my controls are not coming on. I cannot even move my joysticks or buttons. Its like they are just off.

Any help??

FrizzleFried:
You have a ground issue.  The only reason why all controls won't work (aside from a major issue on the PCB) is a ground issue.  I'd bet a $20.00 that's the problem.

Check the ground wire for your buttons.

Matsurigatzu:
I did plug the Motherboard back into the neo geo and the controls work fine. Unplugged it,put it into the Jamma,controls are off.

Still a ground issue you think?

Kevin Mullins:
I just finished helping a fella figure the same problem out..... his issue was a ground problem.
But you may also want to check any dipswitch settings on the multi board itself which tell the multi board what style cabinet/controls you have.
Like "Upright/1 Controls" or something like that. (match it to your setup)

Matsurigatzu:
where do i find the switches on the jamma board?

Navigation

[0] Message Index

[#] Next page

Go to full version