Main > Main Forum

Is primer nessesary?

(1/2) > >>

_JMFR:
After many hours, i FINNALY finished sanding down and smoothing out a cab i'm building. i was debating if i should prime it before i rolled the paint on. Any advice?


* I realize i should maybe move this to the woodworking section.....but the Main board gets the most action!  :laugh:

Blanka:
1 prime layer and 2-3 final layers. Light sanding after every layer, except the last off course. If it is MDF/Particle board, clean the surface first with Aceton  :dizzy:
Final layer paint naked wearing undies and a hairnet, between some wet bedsheets (to prevent dust).
Water paint should be painted horizontal, alkyd paint is best done vertical.

_JMFR:

--- Quote from: Blanka on January 12, 2009, 03:29:05 am ---1 prime layer and 2-3 final layers. Light sanding after every layer, except the last off course. If it is MDF/Particle board, clean the surface first with Aceton  :dizzy:


--- End quote ---

Whats a good primer to use??

Blanka:
Same solution as the final paint, so both water based or both non water based. Sigma Satin U2 is very good stuff.

_JMFR:
where can this sigma satin be found?

Navigation

[0] Message Index

[#] Next page

Go to full version