Main > Main Forum

NOOOOOOOOOO!!!!!

(1/3) > >>

dreamakuma:
I wiped off my x-men cps2. I was gentle, didn't move anything rough. I simply wiped dust off. now nothing. I have no picture, sound or anything, except the whirl of th fan. HELP! :cry: :cry: :cry: :cry:

protokatie:
Check all connections on the traces (resistors, caps, etc). You may have simply broken a solder point. (Lets hope)

Edit: If it is CPS2 (which I think has a suicide battery) you may have killed the battery backed ram (by bumping the battery) that hold the encryption data. There are some people who have broken that system and will "reload" that data for you. (I am not privy to this, but other could help you there).

Kevin Mullins:
What exactly were you dusting off?

Have you checked the power supply yet?

dreamakuma:
I was wiping the blue/plastick with a dry kleenex. the back vent that the fan got wiped and the fans exterior was wiped on the a board as well as the top of it. I have not opened the casing to anything(even the stickers are still there). I had the power off but nothing unplugged,would that do it? I PRAY TO THOR ALMIGHTY that it's the B board that is cheaper to replace. If it's the A board, there goes my first real arcade setup, and maybe my last. I'm freaking out a bit since I've this for two weeks, I started to enjoy it, and now all might be lost.

Bender:
check the back inside panel around the edge for buttons, these switches automatically cut the power when the back panel is removed you may have triggered one even though the panel is closed, hence nothing works, just reset or remove that switch and your good to go.... if that is the problem

I'll cross my fingers for you

EDIT... oops didn't read that the fan was going

Navigation

[0] Message Index

[#] Next page

Go to full version