Main > Main Forum
thoughts on how to switch from horizontal to vertical
(1/1)
_JMFR:
as some of you may know, im converting an old horizontal cab into a vertical. im pretty sure all i hafta do is make a new wood frame that the monitor is mounted on to make it work,but im just looking for some more advice...any helps!
CheffoJeffo:
If the existing board isn't square enough to fit when rotated, then I would cut a new piece using the existing board as a template (just rotate the board 90 degress when tracing the hole).
daywane:
that's what I would do.
I would bet you will have to extend the horizontal sides some.
I have never did this.
the only thing close was a monitor pointing at a mirror.
I removed monitor and mirror and made it vertical
Navigation
[0] Message Index
Go to full version